Share Reliance Wimax Broadband using Linksys WRT54G Wifi Router

Its pretty simple to share reliance wimax broadband using a Linksys WRT54G Wifi router. Just follow the below steps and its working fine at our end.

1. Connect the ethernet (RJ-45) cable (white colour) coming out from Power over Ethernet (POE) to WAN port of the router. At back side of the router your can see 5 RJ-45 ports, out of this 1 for WAN and rest 4 for LAN.
2. Connect your network card of desktop pc or laptop to any of the LAN port of the router.
3. Switch off the power to POE
4. Go to >>>Control panel >> Network >> Local Area Connection >>> Properties >>> Internet Protocol (TCP/IP) >>> Properties >>> Select obtain IP address automatically.
5. Go to Command prompt and type ipconfig/all you should get the details as below

Ethernet adapter Local Area Connection:

Connection-specific DNS Suffix . :
IP Address. . . . . . . . . . . . :
Subnet Mask . . . . . . . . . . . :
Default Gateway . . . . . . . . . :

6.Open your browser (IE / Firefox) and type in the address bar and press ENTER
7. It will prompt for username and password type “admin” for both username and password. Now you are under settings page of your router.
8. Under Setup >>> Basic Setup ,Change the Local IP Address from to (This is very important, because the Subscriber Station (receiver or SS) will have ip address as )
9.Under Setup >>> MAC Address Clone >>> Enable >>> Click “Clone your PC’s MAC” . Then Save settings.
10.Switch on the power to POE and allow atleast 2 mins to complete hand shaking.
11. Under Status >>> Router >>> you can see as below

Login Type: Automatic Configuration – DHCP
IP Address:
Subnet Mask:
Default Gateway:
DNS 1:
DNS 2:
DNS 3:
MTU: 1500

Thats it now you have configured your Wifi router to share your Reliance Wimax Broadband.

This entry was posted in Wimax and tagged . Bookmark the permalink.

Leave a Reply